Saving and Loading Models

You may wish to save models so that they can be loaded and run in a later session. The easiest way to do this is via BSON.jl.

Save a model:

julia> using Flux

julia> model = Chain(Dense(10,5,relu),Dense(5,2),softmax)
Chain(Dense(10, 5, NNlib.relu), Dense(5, 2), NNlib.softmax)

julia> using BSON: @save

julia> @save "mymodel.bson" model

Load it again:

julia> using Flux

julia> using BSON: @load

julia> @load "mymodel.bson" model

julia> model
Chain(Dense(10, 5, NNlib.relu), Dense(5, 2), NNlib.softmax)

Models are just normal Julia structs, so it's fine to use any Julia storage format for this purpose. BSON.jl is particularly well supported and most likely to be forwards compatible (that is, models saved now will load in future versions of Flux).

Saving Model Weights

In some cases it may be useful to save only the model parameters themselves, and rebuild the model architecture in your code. You can use params(model) to get model parameters.

julia> using Flux

julia> model = Chain(Dense(10,5,relu),Dense(5,2),softmax)
Chain(Dense(10, 5, NNlib.relu), Dense(5, 2), NNlib.softmax)

julia> weights = params(model);

julia> using BSON: @save

julia> @save "mymodel.bson" weights

You can easily load parameters back into a model with Flux.loadparams!.

julia> using Flux

julia> model = Chain(Dense(10,5,relu),Dense(5,2),softmax)
Chain(Dense(10, 5, NNlib.relu), Dense(5, 2), NNlib.softmax)

julia> using BSON: @load

julia> @load "mymodel.bson" weights

julia> Flux.loadparams!(model, weights)

The new model we created will now be identical to the one we saved parameters for.

Checkpointing

In longer training runs it's a good idea to periodically save your model, so that you can resume if training is interrupted (for example, if there's a power cut). You can do this by saving the model in the callback provided to train!.

using Flux: throttle
using BSON: @save

m = Chain(Dense(10,5,relu),Dense(5,2),softmax)

evalcb = throttle(30) do
  # Show loss
  @save "model-checkpoint.bson" model
end

This will update the "model-checkpoint.bson" file every thirty seconds.

You can get more advanced by saving a series of models throughout training, for example

@save "model-$(now()).bson" model

will produce a series of models like "model-2018-03-06T02:57:10.41.bson". You could also store the current test set loss, so that it's easy to (for example) revert to an older copy of the model if it starts to overfit.

@save "model-$(now()).bson" model loss = testloss()

You can even store optimiser state alongside the model, to resume training exactly where you left off.

opt = ADAM()
@save "model-$(now()).bson" model opt